 |
|
|
|
|
|
MOLD SEALER - THICKER
|
|
|
|
MOLD SEALER
|
|
|
|
8 oz. Bottle – 1032
|
|
|
|
Mold Sealer is a green single-component natural latex rubber that is designed to seal the edges and holes of metal/plastic casings,
while the potting compounds (i.e.: epoxy, urethane and silicone) cure. Once the potting compound has hardened, Mold Sealer can be removed and discarded.
|
|
|
Mold Sealer is applied using the plastic squeeze bottle supplied by cutting the nozzle to the desired bead size and applying to
selected areas. It will adhere to clean, dry metal or plastic molds.
Mold Sealer cures in approximately 40 minutes at room temperature (22C/72F) and relative humidity of less than 40%. The cure time could vary according to the mask thickness and relative humidity conditions. Optimum thickness would range between 10-30 mils.
|
|
|
Mold Sealer removes easily by hand or tweezers. Simply lift one corner and pull.
A slight lifting action will remove Mold Sealer all in one piece leaving no residue. For best results, Mold Sealer should be removed as soon as possible after the potting compound is cured.
|
|
|
Mold Sealer has a shelf life of 6 months from date of manufacture.
Each container is stamped to show the batch number, date of manufacture and expiration date.
|
|
|
Mold Sealer must be protected from freezing. Store at room temperature in an unopened container.
|
|
|
Please refer to Technical Data Bulletin #TD9000 – The Complete Masking Selection Guide.
|
